12x Screw, M3 x 20, torx

Gear cover kit: 1x Cover, gear drive, 8x Screw, M3 x 18, hex, 1x Cable tie/heat shrink kit.

Thermal spreader kit, 1x Spreader, thermal, 1x Thermal pad, 3x Screw, M3 x 10, torx

GPS PCBA 1x PCB Test Assembely: 2x Screw, torx, no. 6 x 3/8, 1x GPS PCBA cable (not shown in the illustration)

Case seal 1x Seal, case

Top housing assembly 1x Housing, upper assembly (including head decal and indicator decal ring), 14x Screw, torx, no. 6 x 3/4

1x Cable, head to pedal, GHOST 47", 2x Screw, M3 x 10, torx, 1x Seal, strain relief, 1x Cable tie/heat shrink kit, 1x PCBA thermal pad

Lower bezel kit: 1x Bezel, lower, 2x Screw, M3 x 10, torx

OUTER SHAFT

Lower bearing clamp kit: 2x Collar, lower, 2x Screw, M5x20 mm, hex

Bearing cup: 1x Bearing cup

Bearing, sealed kit: 2x Bearing sealed, 2x Bearing wedge, 1x Seal, shaft, 1x Cable tie/heat shrink kit

Nose cone O-ring kit: 1x O-ring, 41x2.62mm, 1x O-ring, 15x3.53mm, 2x O-ring, 84x4.10mm

Propeller hardware kit: 1x Thrust washer, 1x Propeller pin 1x M10 Propeller washer 1x M10 Nylock nut

Propeller kit: 1x Thrust washer, 1x Propeller pin, 1x M10 Propeller washer, 1x M10 Nylock nut, 1 x Propeller

PORTABLE PK 7" & UNDER HOOK2/ELITE TI EMEA

Ghost™ freshwater trolling motor 52", HDI Transducer, Compass

Ghost® freshwater trolling motor 47", HDI Transducer, Compass

Lowrance Link-9 Remote Mountable Fist Mic. Can be connected to the front or rear of the radio, and optional extension cable allows the radio and mic to be mounted in seperate locations.

LINK-9 Fist Mic mounting clip

Link-9 VHF Flush Mounting kit.:Includes teplate, Gasket, Bezels and screws

LINK-9 VHF Suncover

ACTIVE IMAGING 3-IN-1 Trolling Motor Nosecone

HDS-16 LIVE Bezel and SD Card Door