GS25 Antenna with built-in rate compass. 10 Hz position update rate. Built-in rate compass is perfect for providing heading data for Radar Chart Overlay and for orienting charts in Head-Up Mode. Note: This heading sensor is not recommended for MARPA or A

HDI Skimmer® transducer 50/200/455/800kHz with built in temp. Includes mounting bracket and hardware. Cable Length 6 m (20 ft)

CABLE,BB RADAR,EXT EXTENSION,2M

LSS-HD Skimmer Mount Transducer Bracket

StructureScan™ HD Skimmer Transom Mount Transducer

35 m (115 ft) NMEA2000 Wind vane cable (Micro-C male - Simnet)

Triton, T41 Sun Cover

Suncover / protective cover for AP70mk2. Also fits AP80, MX610 and MX612.

AC70 spare PCB assembly. Also option for Voith Schneider propeller control. To be mounted in AC85 Autopilot Computer Cabinet for IMO approved Voith Schneider pilot.

RF70N Medium-duty rudder rudder feedback unit. NMEA2000 interface, comes with transmission link and pre-attached 5.5m cable.

AP70MK2 Bracket Mount Kit. Also for AP70/AP80/MX610/MX612/GN70.

NF80/FU80/QS80 bulkhead Mounting Kit

SI80 Signal Interface PCB with 4 NMEA 0183 RX/TX ports, built-in 12V N2K Network supply. Power input 12-24V DC.

SD80 Solenoid Drive PCB for on/off or proportional control of rudder or thruster using galvanic isolated solenoids or high level current. To be mounted in AC85 Autopilot Computer Cabinet.

AD80 Analog Drive PCB for rudder/thruster, to be mounted in AC85 Autopilot Computer cabinet.

Mast Bracket kit with rubber gasket and screws for the WS310/320, 608/508, and IS20 Wind Sensors.

MOUNTING BRACKET, NSS-12 EVO2, ZEUS2-12

NSS7 MOUNTING BRACKET

RJ45-Yellow Round Ethernet adapter cable RJ45M / 5PinF for products with waterproof RJ45 socket.

SI80 Signal Interface - Four channel NMEA 0183 interface computer board and voltage supply for CAN bus.

SD80 Solenoid Drive Module for on/off or proportional control of rudder or thruster using galvanic isolated solenoids or high level current.

AD80 Analog Drive Module for analog signal control of rudder or a thruster using analog voltage or low level current.

AC70 Autopilot Computer for rudder or propeller (i.e. Voith Schneider), for reversible motor or galvanic non-isolated solenoids.

WS80 Ultrasonic Wind Sensor. Providing wind data in an NMEA0183 data format via RS485 (RS422) data interface. Built to IP66 Rating.