Flush Mounting kit for all Elite-7

HDI TROLLING MOTOR ADAPTOR FOR SKIMMER (*only for 83/200/455/800 HDI Skimmer transducer)

NMEA 2000 Micro-C Auto pilot network starter kit: Includes Network power cable, 4.5 m (15 ft) N2K cable, 3 x T-connectors, and 2 x network terminators.

35 m (115 ft) NMEA2000 Wind vane cable (Micro-C male - Simnet)

20 m (66 ft) NMEA2000 Wind vane cable (Micro-C male - Simnet)

FLUSH MOUNT KIT: 3" ELITE/HOOK

NMEA2000 Cable with 90-degree connectors on both ends. For use on instruments mounted in tight spaces etc where normal cables run too deep behind the unit.

KAYAK SCUPPER HOLE TRANSDUCER MOUNT

Mast Bracket kit with rubber gasket and screws for the WS310/320, 608/508, and IS20 Wind Sensors.

SUNCOVER: 3" MARK/ELITE/HOOK

SPARES KIT FOR T1/T2 BLACK RAMS

WTP3 Analogue Module - Provides analogue data acquisition, and includes a range of input and output options to support a wide variety of sensors.

WTP3 Serial Module - Provides serial data acquisition, and includes a range of input and output options to support a wide variety of sensors.

Low profile trolling motor mount for use with DSI Skimmer transducer. Includes trolling motor snap on mount, stainless steel trolling motor clamp, and 2 zip ties.

WS80 Ultrasonic Wind Sensor. Providing wind data in an NMEA0183 data format via RS485 (RS422) data interface. Built to IP66 Rating.

SUNCOVER: 5" MARK/ELITE/HOOK

Elite/Mark flush mount kit for 5" models

N2KEXT-6RD - 1.82 m (6-ft) NMEA 2000® cable for backbone extension or drop cable to connect an additional network device

TR-120-KIT - Set of 1 male and 1 female NMEA 2000® terminators

Lowrance Power/0183 Cable for HDS, EliteTi/Ti2 and HOOK Gen1 series.

SimNet to N2K Adapter Kit - Connect a SimNet device with a fixed SimNet cable to a NMEA 2000® network; includes SimNet to N2k male adaptor, Simnet inline Joiner, NMEA2000® T connector.

Power Cable for LCX, LMS

NAC-FRD2FBL - Adapter cable to enable connection of a red or black Micro-C NMEA 2000® device to a legacy blue network.

NAC-MRD2MBL - Adapter cable to enable connection of a legacy blue NMEA 2000® device to a red or black Micro-C network