Je winkelwagen is momenteel leeg
30/30HV display for H5000 or Triton systems.
GS25 Antenna with built-in rate compass. 10 Hz position update rate. Built-in rate compass is perfect for providing heading data for Radar Chart Overlay and for orienting charts in Head-Up Mode. Note: This heading sensor is not recommended for MARPA or A
Gimbal mounting bracket with knobs for 9" HDS Gen2 Touch/HDS Gen3/HDS Carbon/Elite-Ti/Hook/Elite-HDI-CHIRP
HDI Skimmer® transducer 50/200/455/800kHz with built in temp. Includes mounting bracket and hardware. Cable Length 6 m (20 ft)
RF25N Rudder Feedback Unit With transmission link and 5 m (16.5 ft) NMEA2000 Micro-C cable and T joiner.
NMEA2000 Cable with 90-degree connectors on both ends. For use on instruments mounted in tight spaces etc where normal cables run too deep behind the unit.
AC70 spare PCB assembly. Also option for Voith Schneider propeller control. To be mounted in AC85 Autopilot Computer Cabinet for IMO approved Voith Schneider pilot.
RF70N Medium-duty rudder rudder feedback unit. NMEA2000 interface, comes with transmission link and pre-attached 5.5m cable.
SI80 Signal Interface - Four channel NMEA 0183 interface computer board and voltage supply for CAN bus.
Dual frequency DSI DownScan Skimmer® transducer 455/800kHz with built in temp. Includes 20ft cable, mounting bracket and hardware.
7pin adapter cable to bare wires. To connect a bare-wire transducer to a display with 7pin sonar port.
HST-DFSBL 50/200 kHz transom-mount skimmer depth/temp - blue 7 pin connector. Cable Length 6 m (20 ft)
XT-12BL 12ft blue 7 pin transducer extension Cable: 3.65 m (12 ft)
Extension cable for 9-pin transducers. *For optimum performance do not use more than 1 extension per installation.
De scheepsset is compleet voor installatie aan boord.
De scheepsset is compleet voor installatie aan boord.
De scheepsset is compleet voor installatie aan boord.