The B&G 213 Masthead Unit PCB (part no. 213-10-101) is the genuine replacement circuit board for the classic B&G 213 windset (masthead unit). When the electronics inside the 213 masthead unit fail or produce unstable readings, this original PCB allows you to restore sensor functionality without replacing the complete windset. It fits directly into the existing 213 housing, preserving the masthead’s mechanical setup and minimizing rig work.

Key features:
• Genuine B&G spare part for the 213 windset
• Restores the electronic function of the masthead unit
• Drop-in fit for the existing 213 housing; no mechanical changes required
• Part number: 213-10-101 (traceable, service-friendly)
• Consistent, reliable wind speed and angle signals after replacement

Use and installation (general):
• Work clean and dry; inspect seals and cable glands and replace if needed.
• Document the original wiring before removal to avoid mistakes.
• After replacement, verify signal stability and perform instrument/system calibration if required on your display/processor.
• Always refer to the official B&G documentation for exact mounting and test procedures.

Support & supply:
Nauticsale supplies original B&G parts with fast delivery and provides practical guidance for installation and commissioning. Unsure if this is the correct PCB for your 213 windset? Contact Nauticsale – our specialists will verify part numbers and compatibility.

Choose the genuine part for reliability and performance. Order the B&G 213 Masthead Unit PCB (213-10-101) at Nauticsale for fast delivery and professional support.