Bottom plate, pedal kit: 1x Bottom plate, pedal, 2x Screw, M5x10 mm, hex, button, SS316, 8x Screw, no. 6x3/4, torx, pan, SS, 4x Rubber foot pedal

Pedal PCBA, potted assembly kit: 1x Potted main controller assembly, pedal, 1x Cable tie/heat shrink kit, 6x Screw M2.5 x 10 T8 PT THR

MISC. HARDWARE,MOUNT KIT

Lower extrusion kit, GHOST 47": 1x Lower extrusion, with bushing, GHOST 47"

Lower extrusion hardware kit: 2x Bolt, rear hinge, 4x Bushing, 1/2”, 2x Washer, M10, 316SS, 2x Jam nut, M10

Pushrod pin kit: 1x Pushrod pin 2x Pushrod pin clip

Latch trigger kit, GHOST 47": 2x Latch trigger, GHOST 47"

Front latch guide kit: 1x Guide, front latch, 1x Spring, extension, front latch

Rear latch kit: 1x Mount rear latch 1x Pin, rear latch pivot

Upper dressing cap kit: 1x Upper dressing cap, 1x Lock pin upper extrusion, 1x Screw, M6x16, hex, flat, SS

Pull cable kit: 1x Pull cable, 1x Handle bottom, 1x Handle top, 1x Barrel, pull cable, 2x Set screw, M4.0 x 0.7 x 6

HDI Nose cone transducer: Traditional 200 kHz High Chirp, 83 kHz Medium Chirp and DownScan 455 kHz, 800 kHz

Slip gear assembly: 1x Gear assembly, 2x Screw, M3 x 20, torx

Steering motor thermocouple kit: 1x Cable assembly thermistor 150 mm, 1x Thermocouple adhesive, 1x PCBA thermal pad

Thermal pad, steering motor: 1x Motor thermal pad

Tensioning bolt kit: 1x Screw, M5x20 mm, hex, socket, SS316, 1x Seal, adjusting screw, O-ring

Steering motor kit: 1x Motor assembly, 1x Motor thermal pad, 1x PCBA thermal pad, 1x Screw, M5x20 mm, hex, socket, SS316, 1x Seal, adjusting screw, O-ring, 4x Screw, M3 x 10, torx, 1x Motor belt

1x Indicator belt

Lowrance label 1x Head decal

Housing hardware 14x Screw, torx, no. 6 x 3/4

Indicator assembly 1x Indicator w/magnet, 1x Indicator ring

2x Nose cone O-ring, 1x Cable tie/heat shrink kit (not shown in the illustration), 1x Column, inner, GHOST 47"/lower unit (pre-assembled)

1x Column, inner shaft, 47"

360 Head HW kit: 2x Screw, SHCS M8 x 1.25 x 20