Upper head adapter pin kit: 1x Pin, upper head, 2x E-clip, 1/2", 15-7 PH SS

Head adapter kit: 1x Head adapter with bushing

Lift assist spring kit, GHOST 47": 1x Gas spring, compression/traction, GHOST 47", 2x Binding barrel, 5/16 x 1”, Pan, PH, SS, 2x Screw, 1/4-20 x 5/16”, Pan, PH, SS

Lower dressing cap kit: 1x Lower dressing cap, 1x Spring, latch extension

Wear bearing kit, GHOST 47": 2x Wear bearing, GHOST 47"

Side plate kit, GHOST 47": 1x Cover mount RH, GHOST 47", 1x Cover mount LH, GHOST 47", 6x Screw, SHCS M4 x 0.7 x14, SS

Kicker kit: 1x Front kicker, 2x Screw, SHCS M6 x 1 x 8

Cable management clip kit: 2x Cable management clips, 2x M4 x 8 socket screw with patch, 2x M4 round base weld nut

Stabilizer, rubber foot: 1x Foot, stabilizer

Rod, stabilizer kit: 1xRod, stabilizer, 1x Nut, 3/4"-10, nylon, 1x Foot, stabilizer, 1x Top cap

Nose cone hardware kit: 1x O-ring, 15x3.53mm, 1x O-ring, 41x2.62mm, 1x Nose cone cap, 1x Bolt, transducer, 2x O-ring, 84x4.10mm

NOSECONE,NOXD

Cable tie/heat shrink kit: 6x Cable tie anchored, 12x Cable tie small, 2x Heat shrink tubing 1.5”

Shaft seal: 1x Seal, shaft

Upper clamp kit: 1x Collar, plain, upper, 1x Collar threaded, upper, 2x Screw, M4x25 mm, hex, socket, SS316

Thermal pad, PCBA: 1x PCBA thermal pad

Head sensor assy: 1x Sensor assembly, 2x Screw, M3 x 10, torx

1x Idler, gear, pully, assembly

1x Motor belt

12x Screw, M3 x 20, torx

Gear cover kit: 1x Cover, gear drive, 8x Screw, M3 x 18, hex, 1x Cable tie/heat shrink kit.

Thermal spreader kit, 1x Spreader, thermal, 1x Thermal pad, 3x Screw, M3 x 10, torx

GPS PCBA 1x PCB Test Assembely: 2x Screw, torx, no. 6 x 3/8, 1x GPS PCBA cable (not shown in the illustration)

Case seal 1x Seal, case