SUNCOVER: 3" MARK/ELITE/HOOK

Gimbal Bracket Knobs for Lowrance, Simrad, B&G MFDs

MOUNTING BRACKET, NSS-12 EVO2, ZEUS2-12

NSS7 MOUNTING BRACKET

RJ45-Yellow Round Ethernet adapter cable RJ45M / 5PinF for products with waterproof RJ45 socket.

SI80 Signal Interface - Four channel NMEA 0183 interface computer board and voltage supply for CAN bus.

SPARES KIT FOR T1/T2 BLACK RAMS

50/200kHz Skimmer™ transducer mounting kit

Paddlewheel spares kit for DST800

VKIT-9 Flush Mount Kit for RS10, RS12 and RS25

WTP3 Analogue Module - Provides analogue data acquisition, and includes a range of input and output options to support a wide variety of sensors.

WTP3 Serial Module - Provides serial data acquisition, and includes a range of input and output options to support a wide variety of sensors.

Replacement mount for Skimmer and top housing.

Low profile trolling motor mount for use with DSI Skimmer transducer. Includes trolling motor snap on mount, stainless steel trolling motor clamp, and 2 zip ties.

Dual frequency DSI DownScan Skimmer® transducer 455/800kHz with built in temp. Includes 20ft cable, mounting bracket and hardware.

SD80 Solenoid Drive Module for on/off or proportional control of rudder or thruster using galvanic isolated solenoids or high level current.

AD80 Analog Drive Module for analog signal control of rudder or a thruster using analog voltage or low level current.

AC70 Autopilot Computer for rudder or propeller (i.e. Voith Schneider), for reversible motor or galvanic non-isolated solenoids.

NF80 Non Follow Up remote unit with display. Take command and Mode buttons. Provides course change in Auto mode.

QS80 Quick-Stick NFU remote unit with display. Take command and Mode buttons. Provides course change in Auto mode.

Compact follow-up (FU) steering lever for direct and precise control with autopilot systems. Ideal for precision steering from a secondary helm position.

WS80 Ultrasonic Wind Sensor. Providing wind data in an NMEA0183 data format via RS485 (RS422) data interface. Built to IP66 Rating.

SUNCOVER: 5" MARK/ELITE/HOOK

7pin adapter cable to bare wires. To connect a bare-wire transducer to a display with 7pin sonar port.