SUNCOVER: 7" ELITE/HOOK

Point-1 GPS antenna provides extremely accurate and rapid boat position and speed updates to the network. Built in magnetic compass provides chart stabilization and radar overlay, plus accurate course over ground even at low speeds. Note: For Autopilot, u

Gimbal mounting bracket with knobs for 12" HDS Gen2 Touch/HDS Gen3/HDS Carbon/Elite-Ti

Gimbal mounting bracket with knobs for 9" HDS Gen2 Touch/HDS Gen3/HDS Carbon/Elite-Ti/Hook/Elite-HDI-CHIRP

Gimbal mounting bracket with knobs for 7" HDS Gen2 Touch/HDS Gen3/HDS Carbon/Hook/Hook2/Hook Reveal/Elite-HDI-CHIRP *Not for use with Elite-7 Ti

HDS Video Adapter Cable

Flush Mounting kit for all Elite-7

HDI TROLLING MOTOR ADAPTOR FOR SKIMMER (*only for 83/200/455/800 HDI Skimmer transducer)

HDI Skimmer® transducer 50/200/455/800kHz with built in temp. Includes mounting bracket and hardware. Cable Length 6 m (20 ft)

HDI Skimmer® transducer 83/200/455/800kHz with built in temp. Includes mounting bracket and hardware. Cable Length 6m (20 ft)

Mark/Elite Tallon Mounting kit

CABLE,BB RADAR,EXTERNAL,5M

CABLE,BB RADAR,EXT EXTENSION,2M

LSS-HD Skimmer Mount Transducer Bracket

StructureScan™ HD Skimmer Transom Mount Transducer

SC20 Mast mount kit for HALO 20/20+ and Broadband Dome Radars.

5 Pin Ethernet cable joiner (Female to Female). Lets you join together two lengths of 5-pin Ethernet Cables. 14 cm (5.5")

NMEA 2000 Micro-C Auto pilot network starter kit: Includes Network power cable, 4.5 m (15 ft) N2K cable, 3 x T-connectors, and 2 x network terminators.

FLUSH MOUNT KIT: 3" ELITE/HOOK

NMEA2000 Cable with 90-degree connectors on both ends. For use on instruments mounted in tight spaces etc where normal cables run too deep behind the unit.

KAYAK SCUPPER HOLE TRANSDUCER MOUNT

Mast Bracket kit with rubber gasket and screws for the WS310/320, 608/508, and IS20 Wind Sensors.

Accessory plug assembly for DST800

SUNCOVER: 3" MARK/ELITE/HOOK